Free U.K. Shipping £20+

Blog

How to make a simple slider card with Ruth Hamilton

Isn't this just the cutest?

As soon as I opened this stamp and die set I knew I had to make a penny slider card! It's snow much fun!

You'll need the following products (all from Tonic Studios)

- Hey Snowmie Stamp Club

- Craft Perfect Bright White 300gsm Smooth Card

- Craft Perfect Arctic Blue Card

- Craft Perfect 5x7 Card Blank

- Nuvo Alcohol Markers -

- Coconut Shell, Skylight Blue, Aqua Spray, Spiced Orange, Violet Breeze, Delicate Rose, Pea Pod, Vine Leaf and Bamboo Leaf.

- Nuvo Deluxe Adhesive

- 3D Foam Squares


PLUS

- 2 pennies

- Die cutting machine

- Craft knife.

Step 1

Stamp the snowmen on the sledge with black ink and colour with the following Nuvo alcohol markers

Coconut Shell, Skylight Blue, Aqua Spray, Spiced Orange, Violet Breeze and Delicate Rose.


Step 2

Use the corresponding die to cut out the image.

Step 3

Stamp the two trees as shown onto a 16.5cm x 11.5cm piece of white card.

Step 4

Die cut masks for the trees, attach with repositionable tape/ dots.

Step 5

Stamp the tree in the centre and remove the masks.

Step 6

Colour with the following Nuvo alcohol markers -

Pea Pod, Vine Leaf, Bamboo Leaf and Coconut Shell


Step 7

Draw a line 2cm up from the bottom and 3.5cm in from each side. Cut a slit on below and above it leaving a 0.5cm gap.

Step 8

Remove the strip of card to leave room for the slider element.

Step 9

Attach 2 foam pads to the surface of 2 pennies/small coins.

Step 10

Place one of the pennies behind the aperture with the foam pads protruding through to the front.

Step 11

Attach the second penny directly on top of the first one.

Step 12

Attach the snowmen die cut directly on top of the pennies.

Step 13

Stamp the sentiment onto white card, trim and layer onto blue card. Glue to the top right of the card.

Step 14

Cover the back of the slider panel with 3D foam pads/tape, leaving room for the penny to move freely across the aperture.

Step 15

Attach to a 17cm x 12cm piece of blue card and glue to the card front.

Step 16

Die cut 3 clouds and glue to the card.

Step 17

Add some detail with the Aqua Shimmer Pen.

I hope you enjoy making this as much as I did 

Buy The Craft Project

Older Post
Newer Post

Leave a comment

All blog comments are checked prior to publishing