Skip to content
Cart

Magazine

'Celebrations Made' Snowflake Bauble - Beginner's Guide

'Celebrations Made' Snowflake Bauble - Beginner's Guide

Shopify API

Step 1 Cut the two largest snowflake outer edge dies and layer together to form the backing for your 3D snowflake. Step 2 To create 3D baubles you need three die cuts of the same bauble die. Fold each die cut and glue half of one bauble to the next. Step 3 Add the final die cut and you bauble is ready to attach. Step 4 Make six of the large round baubles. make six of the smaller shaped baubles. Step 5 Taking the small round bauble die, cut six for your backing layers and another six adding the pattern die, fold and layer these. Step 6 To assemble your 3D Snowflake, adhere the large round baubles evenly to the backing layer, lining up with the shaped edge. Step 7 Next, attach the smaller shaped bauble in between, lining up with the die cut layer on the snowflake backing. Step 8 Add the folded small round bauble to the lower section of the large round bauble. Step 9 Finish with a layered snowflake in the centre, use foam pads to adhere in place. Use Karen's guide to create a variety of gorgeous snowflake designs Click Here To Find out more about the 'Celebrations Made' Tonic Studios Official Magazine Crafting Essentials

Read more

Magazine