Tonic Craftinator - Deco Trellis - a pyramid card from Karen

A simple one for today's Tonic Studios DT Die Release share for today.  I chose to show you this one as it's been shown so much on Create and Craft, you car really see just how fine the trellis work is.

For the pyramid card I used three 14cm squares of white card which I scored diagonally from corner to corner.  The layering was done with 13 cm squares of black pearl paper which was textured with one of the Tonic Studios embossing then cut diagonally corner to corner and stuck on each of the triangular sides of the card panels.

To make sure I was sticking my card together properly, I placed all of the card panels together and held onto them while I laid them flat and proceeded to apply my glue where needed.

The Deco Trellis Frame was cut from matt silver card with one of the matching shaped sentiments layered onto the front, 3d foam pads were added to the back and this was stuck in place.

I cut some flowers using the small flower out of the Flora Frames Topper die set and layered them adding a decorative jewel to the centres.  These were then layered onto the Rococo Poinsettia Wreath die before being stuck onto the corner of the Deco Trellis panel.

The card was finished off with just a few tiny clear gems.

I hope you like the card and that you are enjoying the demonstrations in the Craftinator shows on Create and Craft.  Keep watching for more ideas and inspiration. Check Create and Craft's schedule here. 

See Karen's original post on her blog here. 
Previous article Dot and Drop Flourishes - Claire Rhodes-Brandon