I have quite a few rubber stamps and clear stamps, and I must confess, they are all in a drawer in a great big muddle. When I received my beautiful new Tonic Studios stamps designed by Ruth Hamilton, I knew they deserved a better storage solution to keep them organised and in tip top condition. Here is my solution...
What you will need...
An A4 Ring binder - I got mine at Tesco for about 57p !
Some poly pockets - get good quality ones as it will make cutting them to size much easier.
Double sided sticky tape
Fabric for the cover.
Inkpad suitable for using on Fabric.
Quality Coloured pencils or acrylic paints.
Paper or card for covering the inside
Optional - elastic, hole punch, eyelets and eyelet setting tool.
Measure the size of the stamp sheet and allow extra for when the folder is closed.
For this Tonic Studios range a good size for the side of the cover (not including the spine) is 14.5cm by 23.5cm.
I used some curtain lining cotton fabric and cut a piece about an inch extra all round bigger than the folder. I used the lovely Fuschia and Lily stamps to stamp all over the fabric and then coloured in using my Karisma pencils - which are the same as Prismacolours. You could use watered down acrylic paints or fabric paints for this.
I then pasted glue all over the front of the folder and adhered my fabric. It is best to let it dry before moving on to the next stage. Here you see I am brushing the corners of the fabric with glue and then letting them dry. This is to prevent fraying when I snip the fabric off.
Once it was dry I punched the back of the folder 1inch in from the corners and inserted some elastic which is then held in place with eyelets. This will be to hold the folder closed.
To cover all the raw edges on the inside, I stamped this gorgeous bee stamp from the Lily set ( I love bees) on some lilac card and stuck it down. Next time I do this, I might try and work around the ring mechanism in a different way.
The Poly pockets were cut to a centimetre wider than I needed so I could then snip 1cm of the width of the top layer, fold it over and stick it with double sided sticky tape. Now I can just slide out the stamps I need, use them, and pop them back in again easily.